Heath Zenith Wireless Chime 598-1172-04 - Manual (Page 2)

-2- 598-1172-04
TR -0035-R
X
TR-0095-RX
TYPE
C
5. Adjust volume control. Adjust volume control to desired volume
(see Figure 3).
6. Mount push button. Use either screws or double sided tape to
mount push button.
•
Screw Mounting: To mount with screws, remove back of case
by pushing in tab on bottom with a small screwdriver (see Figure
1). Attach back of case to door jamb or wall (see Figure 5). Snap
front of push button on.
• Tape Mounting: When attaching push button using double sided
tape, make sure the surface of the door jamb or wall is clean.
7. Determine cover mounting type. The cover supplied with the chime base will either snap
onto the base or hang from a cover pin.
•
Snap-On Cover: Apply pressure to the cover until it snaps into place (see Figure 6). To
remove, firmly grasp cover and pull.
• Hanging Cover: Before mounting chime base to wall, slide the cover pin that will be on
top of the mounted base out of the base. Turn it over so the pin is protruding above the
base. Slide the cover pin into base (see Figure 7). Hang cover on cover pin.
Note: Cover pins are located on two sides of the chime base for use with hanging covers. When
chime base is mounted according to mounting orientation marking, use the cover pin located
on the top of the chime base for hanging the cover.
Cover Pin
Chime Base
Figure 6
Snap-On Cover
Mounted
Chime Base
Figure 7
Figure 5