Hearth and Home Technologies CASTILE-PMH1 - Manual (Page 32)

Page 32 250-6422E September 1, 2008
R
Castile Pellet Stove
2. Combustion Blower Replacement
NOTE: The convection blower must be removed
before the exhaust blower can be removed.
a. Turn down thermostat, let appliance completely cool and
then unplug appliance before servicing.
b Remove both side curtains by loosening 2 screws (do
not remove) and pull side panels away.
c. Remove 7 screws from the back screen and pivot the top
of the screen toward you leaving the bottom attached to
stove. Figure 32.1.
d. Remove 2 screws to remove the thermostat block and
disconnect the 2 yellow wires.
e. Remove the 2 screws from the power inlet and rotate it
through the hole and out of the screen, leaving the wires
attached.
f. Disconnect the vacuum hose and both wires (orange
and red) from the vacuum switch attached to the rear
screen.
g. Remove both wires from exhaust blower (blue and
double white).
h. Remove 6 screws using a flathead screwdriver or a 1/4"
nutdriver. Retain screws for use on replacement blower.
Figure 32.2.
i. Remove exhaust blower and gasket.
j. Install new gasket and blower. Discard blower housing
if not needed.
k. Re-install in reverse order.
Figure 32.1
Combustion
Blower
Remove 7 screws and bend top back
leaving it attached at the bottom.
Remove 6 screws
Figure 31.2
Figure 32.3