Hearth and Home Technologies CASTILE-PMH1 - Manual (Page 4)

Page 4 250-6422E September 1, 2008
R
Castile Pellet Stove
1
Listing and Code Approvals
A. Appliance Certification
C. Glass Specifications
E. BTU & Efficiency Specifications
This appliance is equipped with 5mm ceramic glass. Replace
glass only with 5mm ceramic glass. Please contact your
dealer for replacement glass.
This appliance is approved for mobile home installations
when not installed in a sleeping room and when an outside
combustion air inlet is provided. The structural integrity of
the mobile home floor, ceiling, and walls must be maintained.
The appliance must be properly grounded to the frame of
the mobile home and use only listed pellet vent Class “L” or
“PL” connector pipe. A Quadra-Fire Outside Air Kit must be
installed in a mobile home installation.
B. Mobile Home Approved
NOTE: This installation must conform with local codes.
In the absence of local codes you must comply with the
ASTM E1509-95, ULC S627-00 ULC/ORD-C-1482-
M1990 (UM) 84-HUD
D. Electrical Rating
115 VAC, 60 Hz, Start 4.1 Amps, Run 1.1 Amps
*BTU output will vary, depending on the brand of fuel you
use in your stove. Consult your Quadra-Fire dealer for
best results.
NOTE: Hearth & Home Technologies, manufacturer of
this appliance, reserves the right to alter its products,
their specifications and/or price without notice.
Particulate Emis-
sions Rating:
.7 grams/hr
*BTU Output: 8,000 - 30,000 / hr
Heating Capacity: up to 1,500 sq. ft. depending
on climate zone
Hopper Capacity: 40 lbs
Fuel: Wood Pellets or Shelled Corn
Shipping Weight: 258 lbs
Model: Castile Pellet Stove
Laboratory: OMNI Test Laboratories, Inc.
Report No. 061-S-33-2
Type: Solid Fuel Room Heater/Pellet Fuel Burn-
ing Type
Standard: ASTM E1509-95, ULC S627-00 and ULC/
ORD-C1482-M1990 Room Heater Pellet
Fuel Burning type and (UM) 84-HUD,
Mobile Home Approved.
State Listing: State of Colorado