HP 2700 - Manual (Page 128)

Macintosh problems
Solving problems with Mac OS X
The printer driver is not listed in the Print Center or Printer Setup Utility.
Cause Solution
The printer software might not have been installed or was installed
incorrectly. Make sure that the printer PPD file is in the following hard-drive
folder:
Library/Printers/PPDs/Contents/Resources/
<lang>.lproj , where <lang> is the two-letter language code for
the language that you are using. If necessary, reinstall the software.
See the getting started guide for instructions.
The PPD file is corrupt. Delete the PPD file from the following hard-drive folder: Library/
Printers/PPDs/Contents/Resources/<lang>.lproj ,
where <lang> is the two-letter language code for the language that
you are using. Reinstall the software. See the getting started guide
for instructions.
The printer name, IP address, or Rendezvous host name does not appear in the printer list in the Print Center or Printer Setup
Utility.
Cause Solution
The printer might not be ready. Make sure that the cables are connected correctly, the printer is on,
and the ready light is on. If you are connecting through a USB or
Ethernet hub, try connecting directly to the computer or use a different
port.
The wrong connection type might be selected. Make sure that USB, IP Printing, or Rendezvous is selected,
depending on the type of connection.
The wrong printer name, IP address, or Rendezvous host name is
being used. Print a configuration page. Verify that the printer name, IP address,
or Rendezvous host name on the configuration page matches the
printer name, IP address, or Rendezvous host name in the Print
Center or Printer Setup Utility.
The interface cable might be defective or of poor quality. Replace the interface cable with a high-quality cable.
The printer driver does not automatically set up your selected printer in the Print Center or Printer Setup Utility.
Cause Solution
The printer might not be ready. Make sure that the cables are connected correctly, the printer is on,
and the ready light is on. If you are connecting through a USB or
Ethernet hub, try connecting directly to the computer or use a different
port.
The printer software might not have been installed or was installed
incorrectly. Make sure that the printer PPD file is in the following hard-drive
folder:
Library/Printers/PPDs/Contents/Resources/
<lang>.lproj , where <lang> is the two-letter language code for
the language that you are using. If necessary, reinstall the software.
See the getting started guide for instructions.
The PPD file is corrupt. Delete the PPD file from the following hard-drive folder: Library/
Printers/PPDs/Contents/Resources/<lang>.lproj ,
where <lang> is the two-letter language code for the language that
118 Chapter 8 Problem solving ENWW