HP 2700 - Manual (Page 40)

Using the embedded Web server or the HP ToolboxFX
You can use the embedded Web server (EWS) or the HP ToolboxFX to view or change your IP
configuration settings. To access the embedded Web server, type the IP address for the printer in the
address line of the browser.
For complete information about using the embedded Web server and the HP ToolboxFX software,
including instructions about how to open these tools, see
Using the embedded Web server and Using
the HP ToolboxFX .
From the Networking tab (EWS) or the Network Settings tab (the HP ToolboxFX), you can change
the following configurations:
● Host Name
● Manual IP Address
● Manual Subnet Mask
● Manual Default Gateway
NOTE Changing the network configuration might require you to change the browser URL before
you can communicate with the printer again. The printer will be unavailable for a few seconds
while the network resets.
Setting a system password
Use the HP ToolboxFX or the embedded Web server to set a system password.
1. In the embedded Web server, click the Settings tab.
In the HP ToolboxFX, click the Device Settings tab.
NOTE If a password has been set for the printer previously, you will be prompted to type
the password. Type the password, and then click Apply.
2. Click Password.
3. In the Password box, type the password that you want to set, and then in the Confirm
password box, type the same password again to confirm your choice.
4. Click Apply to save the password.
Using the printer control panel
IP configuration
You can configure the IP address manually or automatically.
Manual configuration
1. On the control panel menu, press OK .
2. Use the < or the > button to select Network Config., and then press OK .
3. Use the < or the > button to select TCP/IP config, and then press OK .
30 Chapter 3 I/O configuration ENWW