HONDA Automobile Accessories - Manual (Page 5)

© 2000 American Honda Motor Co., Inc - All Rights Reserved. AII 21619 (0008) 5 of 10
12. Push the wire tie with clip into the hole in the back
of the control unit bracket. Position the control unit
bracket on the driver's dashboard lower cover, and
install the three self-tapping screws from the kit.
14. From the driver's side, route the 14-pin connectors
of the keyless entry wire harness to the left fuse
box. Unplug the vehicle harness 14-pin connector
from the fuse box, and plug the 14-pin connectors
of the keyless entry wire harness in between.
13. Position the control unit on the control unit bracket,
and install the two 4 x 30 mm washer-screws.
Secure the antenna to the control unit bracket with
the wire tie with clip you just installed. Secure the
antenna to the control unit bracket, parallel with the
control unit.
WIRE TIE
WITH CLIP
CONTROL
UNIT
BRACKET
BACK OF DRIVER'S
DASHBOARD
LOWER COVER
SELF-
TAPPING
SCREW
ANTENNA
WIRE TIE WITH CLIP
CONTROL UNIT
BRACKET
CONTROL
UNIT
4 x 30 mm
WASHER-
SCREW
KEYLESS
ENTRY WIRE
HARNESS
VEHICLE HARNESS
14-PIN CONNECTOR
LEFT
FUSE BOX
KEYLESS ENTRY
WIRE HARNESS
14-PIN CONNECTOR