HONDA Automobile Accessories - Manual (Page 8)

8 of 10 AII 21619 (0008) © 2000 American Honda Motor Co., Inc - All Rights Reserved.
23. Assemble three fuse cases as shown. Attach the
appropriate fuse label to each fuse case of the
keyless entry wire harness, then attach the
connector clip as shown.
26. Position the 5-pin and 4-pin relays on the relay
bracket, and install the 6 mm washer-bolt and
6 mm nut.
24. Position one relay bracket on the left knee bolster,
and install one 6 x 12 mm washer-bolt and one
6 mm flange nut. Push the connector clip on the
fuse case of the keyless entry wire harness into
the hole in the relay bracket.
25. Secure the keyless entry wire harness to the
vehicle harness with one long wire tie in the area
shown.
27. Plug the 6-pin and 4-pin connectors of the keyless
entry wire harness into the 5-pin and 4-pin relays;
then attach the other relay bracket to the steering
hanger beam with the other 6 x 12 mm washer-bolt
and one 6 mm flange nut.
FUSE CASE
OF KEYLESS
ENTRY WIRE
HARNESS
FUSE LABEL
(15 A)
FUSE LABEL
(5 A)
6 x 12 mm
WASHER-
BOLT
RELAY
BRACKET
LONG
WIRE TIE
CONNECTOR
CLIP
LEFT
KNEE
BOLSTER
VEHICLE
HARNESS
6 mm
FLANGE
NUT
6 mm
FLANGE
NUT
4-PIN
RELAY
5-PIN
RELAY
5-PIN RELAY
6 mm
WASHER-
BOLT
RELAY
BRACKET
About
45°
5-PIN RELAY
(with 6-pin
connector)
6-PIN
CONNECTOR
4-PIN
RELAY
4-PIN
CONNECTOR
5-PIN RELAY
6 x 12 mm
WASHER-
BOLT
STEERING HANGER BEAM
6 mm
FLANGE NUT
4-PIN
RELAY