Husky 1800 - Manual (Page 26)

26
PROBLEM OR CONCERN POSSIBLE CAUSE SOLUTION
Wand is malfunctioning Test both wands to ensure that one is not mal-
functioning.
Gun is not operating properly Remove Wand from the Gun and squeeze trigger to
ensure that the water is coming out of the front of the
Gun at a rate equal to the Garden Hose.
Wand - Attaching To attach the Wand apply some moderate
downward pressure force on the Wand (In the di-
rection of the trigger) while simultaneously twisting
the wand a 1/4 of a turn counterclockwise. (It may
help if you set the gun vertically on a flat surface
with the wand pointing upwards). The two tabs on
the end of the Wand must slide all the way in before
the Wand will twist and lock. If this does not work
remove the o-ring from the end of the wand and
attach it without the o-ring. If the wand attaches,
you will need to replace the o-ring. Contact us at
customerservice@huskypowerwasher.
com
or order a replacement directly online at
www.huskypowerwasher.com .
Wand - Removing Release the back pressure in the Gun/Hose. Re-
move the Garden Hose from the unit and squee-
ze the trigger of the Gun. Apply some moderate
downward pressure force on the Wand (In the
direction of the trigger) while simultaneously
twisting the wand a 1/4 of a turn clockwise. (It
may help if you set the gun vertically on a flat
surface with the Wand pointing upwards). For
additional assistance you can email us at custo
[email protected].
Wand - Gray collar won’t
turn/won’t adjust from low
to high pressure
To turn the gray collar, hold the Wand hori-
zontally in both hands. Hold the collar firmly
in one hand and the shaft of the Wand in the
other hand. It works best if you grab the shaft
by the “beehive” shaped portion at the bottom
of the Wand. Sometimes it gets tightened down
too far and needs some extra force to move it.
For additional assistance you can email us at
customerservice@huskypowerwasher.
com.