Harbor Freight Tools 40315 - Manual (Page 12)

SKU 40315 For technical questions, please call 1-800-444-3353. Page 12
UNPACKING
When unpacking, check to make sure all the parts shown on the Parts List on page 16
are included. If any parts are missing or broken, please call Harbor Freight Tools at the
number shown on the cover of this manual as soon as possible.
1. WARNING! Make sure the Power Switch (21) of the Tile Saw is in its
“OFF” position and its Power Cord/Plug (34) is unplugged from the electri-
cal outlet prior to performing any assembly.
2. The Tile Saw may be temporarily placed upon a workbench for use. Also, the
Tile Saw may be permanently mounted on a workbench.
3. CAUTION! Make sure the workbench on which the Tile Saw will be tempo-
rarily or permanently used is flat, level, and sturdy enough to support the weight
of the Tile Saw, any workpieces, and any additional tools.
4. To permanently mount the Tile Saw on a workbench, place the Tile Saw in the
desired work location on the workbench. Use the four 7/16” wide x 3-1/2” long
mounting slots at the base of the Inner Cover (16) as a template to mark the
areas where four 7/16” diameter mounting holes should be drilled through the
workbench.
5. Temporarily remove the Tile Saw, and drill the four 7/16” diameter mounting holes
through the workbench, making sure no hidden electric cords or cables are in the
drilling path.
6. Once the mounting holes are drilled, align the four 7/16” wide x 3-1/2” long
mounting slots in the base of the Inner Cover (16) with the four predrilled mount-
ing holes in the workbench. Secure the Tile Saw to the workbench, using four
appropriate length Bolts, Lock Washers, and Nuts (not included).
ASSEMBLY AND OPERATING INSTRUCTIONS
NOTE:
For additional references to the parts mentioned in the
following pages, refer to the Assembly Diagram on page 17.
To Permanently Mount The Tile Saw On A Workbench: