Harbor Freight Tools 40315 - Manual (Page 13)

SKU 40315 For technical questions, please call 1-800-444-3353. Page 13
ON OFF
To Attach The Star Knob:
1. The Star Knob (53) is used to lock the Cutting Guide (57) in position. The Cutting
Guide is used to set the desired
width of cut when cutting a workpiece.
(See Figure F.)
2. To attach the Star Knob (53), place the Cutting Guide (57) on the Table (51) of
the Tile Saw. Place the Clamping Plate (56) behind the edge of the Table. Insert
the threaded portion of the Star Knob through the Cutting Guide and screw the
Star Knob into the Clamping Plate. (See Figure F.)
STAR KNOB
(53)
CLAMPING PLATE
(56)
EDGE OF
TABLE
(51)
CUTTING GUIDE
(57)
FIGURE F
To Prepare To Cut:
1. Fill the Tray (17) with water and carefully slide the Tray under the Cutting Wheel
Blade (8). Make sure the water level is deep enough to cover the lower edge of the
Cutting Wheel Blade, but not so deep as to spill over the edge of the Tray. (See
Figure G.)
TRAY
(17)
FIGURE G
TABLE
(51)
POWER SWITCH
(21)
STAR KNOB
(20)
CUTTING GUIDE
(57)
CUTTING WHEEL BLADE
(8)
STAR KNOB (53)