HONDA BC4050 - Manual (Page 11)

BAGGER CART ASSEMBL Y
14. Thread the dump cloth rod through the sleeve
in the rear edge of the dump cloth.
Position the dump cloth with the connecting
sleeve cut-out at the right side of the cart.
Insert the ends of the rod through the holes in
the rear corners of the
cart.
Secure each end of the rod by installing a circle
clip outside the cart bed.
DUMP CLOTH
DUMP CLOTH ROD
CIRCLE CUP
15. Spread out the dump cloth in the cart box, and
hook the four plastic clips onto the support
tube.
16. Install a rubber strap and hooks on the washer
at the center of the cover frame rod. The open
end of the lower hook must face the cart bed.
Secure the upper hook to the frame rod by
closing the hook loop with pliers.
To hold the cover closed, hook the lower end to
the cart bed as shown.
RUBBER ROD WASHER
Hitch Assembly
17. Install the hitch bracket on the rear of the
tractor, using one 1/2 x 1 inch hex bolt, one
inch lock washer, one
1/2 inch nut,
four 8 x 20 mm hex bolts and four 8 mm lock
washers.
Tighten the nuts and bolts securely.
HITCH BRACKET
\
x 1 inch HEX BOLT
LOCK WASHER
inch NUT HEX BOLT
Page 5