HONDA BC4050 - Manual (Page 13)

BAGGER CART ASSEMBLY
21. Install two figure-8 hook loops on the
connecting sleeve using
two 6 x 3/4 inch
slotted truss head screws (inserted from inside
the connecting sleeve), two 5/16 inch flat
washers and two 5/16 inch lock nuts.
Position the figure-8 hook loops so they face
the opening of the connector sleeve.
Tighten the nuts securely.
x inch
TRUSS
inch LOCK
22. Attach three locking straps to the discharge
chute assembly.
a.) Attach one rubber strap to the middle chute
by inserting
a 5/16 x 1 inch pan-head screw
(Phillips) from inside the chute. Thread the
rubber strap onto the screw hook
toward the flex Secure with the 6
flat washer and the 6 lock nut.
5/16 X 1 inch PHILLIPS
PAN-HEAD SCREW
MIDDLE CHUTE
inch
FLAT WASHER
Inch
RUBBER STRAP
b.) Install rubber straps on the flex hose by
inserting two 5/16 x 1 inch pan-head screws
(Phillips) with two 5/16 inch fender washers
from inside the flex hose. Thread the rubber
straps onto the screws
hooks away
from the flex hose). Secure with two 5/16 flat
washers and the 5/16 lock nuts.
RUBBER STRAP (2)
NDER WASHER (2)
23. Install the middle chute assembly by inserting
the flexible end into the connecting sleeve and
placing the other end on the lower chute.
Position the middle chute assembly so the
window faces the driver’s seat.
Attach the two upper hooks to the hook loops
on the connecting sleeve.
Attach the lower hook to the hook loop on the
lower chute.
CONNECTING
MIDDLE CHUTE
Page 7