Document Outline

• Front cover
• Quick Start
• Table of Contents
• Chapter One • Introduction
  • About this Manual
  • About the Matrix Switchers
  • Definitions
  • Features
• Chapter Two • Installation
  • Mounting the Switcher
    • UL requirements
    • Mounting instructions
  • Connections and Rear Panel Features
    • RGBHV input and output
    • Audio input and output (HVA models only)
    • Remote (RS-232/RS-422) port
    • Reset button
    • Sync termination switches
    • Power
  • Front Panel Configuration Port
• Chapter Three • Operation
  • Front Panel Controls and Indicators
    • Definitions
    • Input and output buttons
    • Control buttons
    • I/O controls
  • Front Panel Operations
    • Front panel security lockouts
    • Power indications
    • Creating a configuration
      • Example 1: Creating a set of video and audio ties
      • Example 2: Adding a tie to a set of video and audio ties
      • Example 3: Removing a tie from a set of video and audio ties
    • Viewing a configuration
      • Example 4: Viewing video and audio, audio-only, and video-only ties
    • Muting and unmuting video and/or audio
      • Example 5: Muting and unmuting an output
    • Using global presets
      • Example 6: Saving a preset
      • Example 7: Recalling a preset
    • Viewing and adjusting the input audio level (HVA models)
      • Example 8: Viewing and adjusting an input audio level
    • Viewing and adjusting the output volume (HVA models)
      • Reading the displayed value
      • Example 9: Viewing and adjusting an output volume level
    • Setting the front panel locks (Executive modes)
      • Selecting Lock mode 2 or toggling between mode 2 and mode 0
      • Selecting Lock mode 2 or toggling between mode 2 and mode 1
    • Performing a system reset from the front panel
    • Selecting the rear panel Remote port protocol and baud rate
  • Rear Panel Operations
    • Performing a system reset from the rear panel
    • Performing a hard reset from the rear panel
  • Optimizing the Audio (HVA Switchers)
  • Troubleshooting
    • General checks
    • Plasma display S-video problem
  • Configuration Worksheets
    • Worksheet example 1: Entering system equipment
    • Worksheet example 2: Drawing ties
    • Worksheet example 3: Test configuration
    • Matrix Switchers Configuration Worksheet
• Chapter Four • Programmer’s Guide
  • Serial Ports
    • Rear panel Remote port
    • Front panel Configuration port
  • Host-to-Switcher Instructions
  • Switcher-Initiated Messages
  • Switcher Error Responses
  • Using the Command/Response Table
  • Command/Response Table for SIS Commands
    • Symbol Definitions
• Chapter Five • Matrix Software
  • Matrix Switchers Control Program
    • Installing the software
    • Using the software
    • Updating the firmware
    • Windows buttons, drop boxes, and trash
    • Windows menus
      • File menu
      • Tools menu
      • Audio-input Configure selection
      • Preferences menu
    • Using emulation mode
    • Using the help system
  • Button-Label Generator
    • Using the software
• Appendix A • Reference Information
  • Specifications
  • Part Numbers
    • CrossPoint 300 part numbers
    • Included parts
    • Optional accessories
    • Cables
      • Bulk cable
      • Assorted connectors
      • Pre-cut cables
  • Button Labels
    • Button label blanks