Extron Electronics CrossPoint 300 Series - Manual (Page 76)

Programmer’s Guide, cont’d
CrossPoint 300 Matrix Switchers • Programmer’s Guide 4-6
Command/Response Table for SIS Commands
Symbol Definitions:
= Carriage return/line feed
= Carriage return (no line feed)
• = Space
Esc
= Escape key
Input and output numbers in commands may be entered as either 1-digit, 2-digit, or 3-digit
numbers. All input and output numbers are reported as 2-digit numbers in the response.
X1
= Input number 01 – 08 (CrossPoint 300 84/88/816);
01 – 12 (CrossPoint 300 124/128);
01 – 16 (CrossPoint 300 168/1616)
X2
= Input number (for tie) 0 – maximum number of inputs (0 = disconnected)
X3
= Output number 01 – 04 (CrossPoint 300 84/124);
01 – 08 (CrossPoint 300 88/128/168);
01 – 12 (CrossPoint 300 1212);
01 – 16 (CrossPoint 300 816/1616)
X4
= Mute, Lock mode, power supply (0 = off/mode 0/not OK, 1 = on/mode 1/OK, 2 = mode 2)
X5
= Numeric dB value –18 to +24 (45 steps of gain or attenuation)
X6
= Audio gain 0 – 24 (1 dB/step) (default = 0 dB)
X7
= Audio attenuation 1 – 18 (1 dB/step)
X8
= Volume adjustment range 0 – 64 (1 dB/step except for 0-to-1, which is 22 dB)
(default = 64 [0 dB])
X9
= Global preset # 0 – 32 (0 = current configuration)
X10
= Video/audio mute 0 = no mutes 2 = audio mute
1 = video mute 3 = video and audio mute
X11
= Firmware version number to the
second decimal place (x.xx)
X12
= Verbose firmware version-description-upload date/time.
See the Query software version (verbose) command on page 4-12.
X13 = Name 12 characters maximum for global preset names.
Upper- and lower-case alphanumeric characters and
_ / and spaces are valid.
The following characters are invalid in the name: + ~ , @ = ‘ [ ] { } < > ’ “ ; : | \ and ?.
X14
= Baud rate 9600, 19200, 38400, 115200
X15 = Parity O dd, even, none, mark, space (only the first letter is
required)
X16 = Data bits 7, 8
X17 = Stop bits 1, 2
X18
= Port type 0 = RS-232, 1 = RS-422
X19
= Voltage Positive or negative voltage magnitude
X20
= Temperature Degrees Fahrenheit