Extron Electronics CrossPoint 300 Series - Manual (Page 12)

Introduction, cont’d
CrossPoint 300 Matrix Switchers • Introduction 1-4
Features
Video — All switchers input and output wideband RGBHV or RGBS video on
female BNC connectors. They can also switch RGsB, RsGsBs, component/
HDTV, S-video, or composite video.
Bandwidth — The CrossPoint 300 Series switchers provide a minimum of
300 MHz (-3 dB) video bandwidth, fully loaded.
Audio inputs (HVA models only) — Input and output stereo audio inputs,
balanced or unbalanced, on 3.5 mm, 5-pole captive screw terminals.
Audio input gain/attenuation (HVA models only) — Individual input audio levels
can be adjusted so there are no noticeable volume differences between
sources. Users can set the input level of audio gain or attenuation
(-18 dB to +24 dB) via either serial port or the front panel.
Audio output volume (HVA models only) — The audio volume of each output can
be displayed and adjusted through a range of full output to completely silent
from the front panel or via serial port control.
Switching flexibility — The CrossPoint 300 series units provide individually
buffered, independent matrix switched outputs with audio follow and audio
breakaway for audio models.
• Tie any input to any or all outputs
• Quick multiple tie — Multiple inputs can be switched to multiple outputs
simultaneously. This allows all displays (outputs) to change from source to
source at the same time.
• Audio follow — Audio can be switched with its corresponding video input
via front panel or serial port control.
• Audio breakaway — Audio can be broken away from its corresponding
video signal. This feature allows any audio signal to be selected with any
video signal simultaneously to one or all outputs in any combination. Audio
breakaway switching can be done via front panel control or under serial port
control.