Document Outline

• lASCAM
  • TEAC Professional Division
    • SECTION 1 : INTRODUCTION
      • SECTION 1: INTRODUCTION
      • Table of Contents
    • SECTION 3 : FORMAHING A TAPE
      • IMPORTANT
        • Assigning a machine ID number to each of the DA-38s
      • IMPORTANT
      • IMPORTANT
      • NOTE
    • SECTION 4: RECORDING
      • 4-1. Recording Analog Input (basic operation)
        • (1) Using RECORD and PLAY
        • SECTION 4: RECORDING
          • (2) REC FUNCTION-triggered Recording
          • NOTES
            • (3) Footswitch-controlled Recording
        • 4-3. Punch In/Out Editing
          • (1) Rehearsal
      • 4 6 7 5 2
        • (2) Setting Punch In and Out Points
        • (3) Auto Punch In and Out
          • Autolocation
        • (4) Punch In and Out at Points Captured on the Fly
      • 3 2
        • 4-4. Crossfade Time Setting
        • 4-5. Preroll Time Setting
      • 15
        • 4-6. Postroll Time Setting
        • 4-7. Copying Tracks
      • 3 2
      • 14
        • TRK COPY 4-
        • Target track selection (REC FUNCTION)
        • 4
          • Source selection {▲ / t)
        • 4
          • RECORD + PLAY
          • PRECAUTIONS
            • (1) Copying in Stereo Pairs
      • r.
        • (2) Copying Tracks of One DA-38 to Tracks of Another
        • WARNING
          • (3) Using the Track Copy Capability as a Patch Bay
          • (4) To Switch Off the Track Copy Mode
          • (5) Track Copy Settings Backed Up
        • 4-8. Dithering the Re-quantization Noise
      • 14
    • SECTIONS: PLAYBACK
      • 5-1. Basic Playback Procedure
      • 43
        • WARNING
        • IMPORTANT
        • NOTES
          • To Change the Current Pitch
      • 1 4
        • (2) Keying in Locations
        • (1) Setting Locations On The Fly
        • 5-5. Repeat Play
          • NOTES
    • SECTION 6: AUTOLOCATION
      • 6-1. Autolocating to Either of Two Location Points
      • 6-2. Setting Autolocation Preroll Time
      • 1 4
        • 6-3. The Auto Play Function
    • SECTION 8 ; CONTROLLING THE DA-38 FROM MENUS
      • How to Access Menus
      • Menus Explained
      • 8-2. Using the Built-in Oscillator
        • (1) Accessing the Oscillator Menu
        • (2) To Monitor the Sine Wave Tone
        • CAUTION
          • (3) How to Record the Sine Wave Tone on Tape
      • 8‘3. Initializing the Backup Memory
      • 8-4. Selecting a TDIF Input Bit Length
    • SECTION 9 : MONITOR AND OTHER CAPABILITIES
      • (2) Insert Monitor
      • (1) All Input Monitor
      • (3) Auto Input monitor
      • 32 14
        • NOTES
        • NOTE
        • 9-2. Capabilities to Assist In Saving Your Time
        • 9-3. To See the System Version
          • (1) To Clear the Currently Displayed Number
          • (2) To Speed Up the Keying In of Numbers
          • (1) To Display the SYSCON ROM Version
          • (2) To Display the SERVO Microcomputer
        • 11-3. Error Messages Explained
          • Other Messages
  • TASCAM
    • TEAC Professional Division