Tascam DA-38 - Manual (Page 32)

SECTION 9 : MONITOR AND OTHER CAPABILITIES
This section explains the DA-38’s capabilities that assist
in streamlining the recording, playback, and synchroniza­
tion operations.
9-1. Monitor Functions
This paragraph explains the following monitor functions :
• All Input
• Insert
• Auto Input
• Shuttle
Relationship between those functions and the transport
modes is shown in table below.
(2) Insert Monitor
This function causes the outputs to be switched between
tape and input depending on transport modes, as shown in
the table below.
(1) All Input Monitor To switch the function on :
ALL INPUT is used to switch the eight outputs to be fed
directly by the corresponding inputs.
To switch on the function :
Y Press ALL INPUT and the associated LED will light
solidly to show the unit is in Auto Input mode.
Y Press INSERT and the associated LED will light
solidly to indicate that the unit is in Insert monitor
mode.
NOTES
If the DA-38 is not remote controlled, the INSERT
key switches on or off not only the insert monitor
function but also the next auto input monitor function.
* When the INSERT LED is lit:
Both the insert and the auto input monitor modes
are activated.
. • When the INSERT LED is turned off:
Both the insert and the auto input monitor func­
tions are disabled.
If you are using the optional RC-848 remote contol
unit, you can switch the insert and the auto input
monitor functions on/off separately.
MONITOR SWITCHING
REG
FUNCTION
PLAY RECORD
STOP
F FWD, REW
SHUTTLE
ALL INPUT ON
ON INPUT INPUT INPUT INPUT
OFF INPUT INPUT INPUT INPUT
ALL
INPUT
OFF
INSERT OFF
ON INPUT INPUT INPUT INPUT
OFF TAPE TAPE MUTE TAPE
INSERT
ON
AUTO INPUT
OFF
ON TAPE INPUT MUTE TAPE
OFF TAPE TAPE MUTE TAPE
AUTO INPUT
ON
ON TAPE INPUT INPUT
SHTL. M OFF TAPE
SHTL, M ON INPUT
OFF TAPE TAPE MUTE
SHTL. M OFF TAPE
SHTL. M ON MUTE
9-1