Fisher & Paykel OR120 - Manual (Page 11)

9
=
=
Dotted line showing the position
of the cooker when installed
Rear central
foot of cooker
Anti-tilt
bracket
Fitting the anti-tilt bracket
Important!
To restrain the appliance and prevent
it tipping accidentally, the anti-
tilt bracket and restraining plate
supplied must be fitted according to
the instructions below.
1 Drill four 8mm diameter holes for
the fixing screws (two in the wall
and two in the floor-see Fig.5) and
insert the plastic plugs supplied.
Important!
Before drilling the holes, check that you will not
damage any pipes or electrical wires.
2 Attach the anti-tilt bracket to the floor and
rear wall using the four screws supplied, as
shown in Fig. 5.
3 After attaching the anti-tilt bracket securely,
slide the cooker into place. Ensure that the
rear central foot slides under the bracket, as
shown in Fig.5.
4 Access the bracket by removing the left
drawer (Fig. 6):
a Slide out the left drawer completely.
b Press the lever of the left guide rail
down and pull the lever of the right
guide rail up.
c Holding the levers, disengage and
remove the drawer.
5 Fix the restraining plate by sliding it into
place and securing it with the fixing screw
and washer supplied. See Fig. 7.
6 Replace the left drawer (Fig. 8):
a Insert the drawer rails into the guide
rails.
b Gently push the drawer in
completely; the safety catches will
automatically hook.
Important!
Beware of sharp edges when removing or
replacing the drawer.
Installation instructions
Fig. 5 Attaching the anti-tilt bracket and
sliding the cooker into place
Fig. 6 Accessing the anti-tilt bracket
by removing the left drawer
Fig. 8 Replacing the left drawer
Fig. 7 Fixing the restraining plate
Restraining plate
Screw & Washer