Fisher & Paykel OR120 - Manual (Page 20)

18
Installation instructions
C
D
A
B
Power supply
220 - 240V ~ 5300W 50Hz
PE
1 2 3 4 5
N (L
2
) L
1
220-240 V
Red or
Brown
(Live)
Black or
Blue
(Neutral)
Green
and
Yellow
(Earth)
2 3 4 5 1
N(L2) PE L1
PE Earth
N Neutral
L Live
Connecting the power supply cable
To connect the power supply cable to the
cooker:
1 Remove the four screws that hold shield “A”
behind the cooker.
2 Open the cable clamp “D” completely.
3 Check the position of the U bolts on the
terminal block “B” (Fig. 16a) corresponds to
the connection diagrams in Fig. 16b and
Fig. 16c.
4 Insert the power supply cable into the cable
clamp “D” and into the cable protector
“C”. The supply cable must be of a suitable
size for the current requirements of the
appliance.
This cooker must be connected to the
power supply using V105 insulated cable.
This cooker must be earthed.
5 Connect the phase and earth cables to
terminal “B” according to Figs. 16b and 16c.
6 Tighten the power supply cable and fix it
with the cable clamp “D”.
7 Re-mount shield “A”, securing it tightly with
the four screws.
Note: the earth conductor must be left
about 30 mm longer than the others.
Fig. 16a Accessing the terminal block
Fig. 16b Electrical connection
Fig. 16c Connection diagram
Green
and
Yellow
(Earth)
Black
or Blue
(Neutral)
Red or
Brown
(Live)