Fisher & Paykel OR120 - Manual (Page 24)

22
Using your gas cooktop
Before using your cooktop
Before using your new cooktop, please:
Read this user guide, taking special note of the ‘Safety and warnings’ section.
Switch the power to the cooker on at the wall.
Make sure all burner control knobs are turned off.
Using the gas burners (semi-rapid and triple-ring wok)
1 Choose the control knob for the burner you want to use.
2 Press the knob down gently and turn it anticlockwise to the position. The ignitors on all the
burners will spark.
Hold down the knob for approximately 10 seconds after the burner has lit. Releasing the knob
too soon will extinguish the flame.
3 Adjust the flame anywhere between the and positions. Do not adjust the flame between
and
0
/ OFF.
Note: if the burner does not light within 15 seconds, turn the control knob off and wait at least
one minute before trying again.
4 To switch the burner off, turn the knob clockwise until you hear the safety click.
5 After use, always turn the knobs to the
0
/ OFF position.
Flame failure safety feature
The flame failure probe cuts off the gas supply to the burner if the flame is blown out.
When lighting the burner, hold down the knob for approximately 10 seconds after the burner
has lit. Releasing the knob too soon will extinguish the flame.
If the flames are accidentally extinguished, turn off the burner and do not try to light it again for
at least one minute (to allow the gas to disperse).
Using the dual gas burners
These burners are very versatile. By controlling
the inner crown and the two outer crowns
separately, you can use them when you need
a small burner or a high-powered one.
.
Fig. 20 Dual crown burners