Fisher & Paykel OR120 - Manual (Page 14)

12
Connecting the cooker to the gas
supply
The gas connection must be carried out by an
authorised person according to the relevant
standards.
Before connecting the appliance to the gas
main, mount the brass conical adaptor onto
the gas inlet extension pipe, upon which
the washer has been placed (see Fig. 12
following).
Conical adaptor and washer are supplied with
the appliance (packed with conversion kit for
use with Natural gas or LPG).
This appliance is suitable for use with Natural
gas or LPG gas. (Check the “gas type” sticker
attached to the appliance).
For Natural gas, connect the gas supply to
the gas pressure regulator which is supplied
with the appliance (Fig.12). Adjust the
regulator to obtain a test point pressure of
1 kPa with the two triple-ring wok burners
operating at the maximum.
For LPG, connect the gas supply to the test
point adaptor which is supplied with the
appliance (Fig.12). Ensure that the supply
pressure is regulated to 2.75 kPa.
The connection must be made at the rear of
appliance; the pipe is not to cross the cooker.
If the connection pipe does cross the cooker,
it must be positioned under the cooker’s back
panel, as shown (Fig.11).
Important!
Use two spanners to tighten or loosen the
connecting pipe and the gas components (Fig.13).
Installation instructions
Gas connection for
NATURAL GAS
Gas inlet pipe
Test point
Nipple
Washer
Extension pipe
Brass conical
adaptor
(Thread tight:
use suitable seal)
Gas pressure
regulator
Test point
Nipple
Nut
Washer interposed
between nipple and nut
Gas connection for
LPG
Gas inlet pipe
Nipple
Washer
Extension pipe
Brass conical
adaptor
(Thread tight:
use suitable seal)
Test point adaptor
Test point
Test point
Nipple
Nut
Washer interposed
between nipple and nut
Back
panel
Fig. 13 Adjusting the connecting pipe
Fig. 12 Gas connection options
Fig. 11 Gas pipe positioning options