Ferris Industries IS4500ZC28D61CE - Manual (Page 11)

9
PTO (Power Take Off) Switch
The PTO switch engages and disengages the mower.
Pull UP on the switch to engage the mower, and push
DOWN to disengage the mower.
Throttle Control
Moving the throttle control fully forward is FULL throttle
position. Always operate the unit at FULL throttle when
mowing.
Choke (gas model only)
Close the choke for cold starting. Open the choke once
the engine starts. A warm engine may not require chok-
ing. Pull the knob UP to close the choke. Push to knob
DOWN to open the choke.
Parking Brake
DISENGAGE Releases the parking brake.
ENGAGE Locks the parking brake.
Pull the parking brake lever back to engage the parking
brake. Move the lever fully forward to disengage the
parking brake.
NOTE: To start the unit the parking brake
must be engaged.
Deck Lift Pedal, Cutting Height
Adjustment Pin & Deck Lift Lock Lever
These control the cutting height of the mower deck.
Depress the pedal until it locks into the 6” (15,2 cm)
position. Place the adjustment pin in the desired cutting
height and release the lift lock lever.
Hour Meter / Maintenance Reminder
Measures the time of the PTO being engaged. The hour
meter measures the number of hours the PTO has been
engaged. The hour meter will flash an initial oil change
indicator at 5 hours, and a lubrication reminder every 50
hours. These reminders display for approximately two
hours and will automatically reset themselves.
Note: The hour meter will register the passage of time
only when the PTO is engaged. The hour meter has a
self contained power source so the total hours are
always visible.
Glow Plug Indicator (diesel model only)
Lamp that indicates that the glow plugs are heating.
Hold the ignition key in the “HEAT” position until indicator
lamp turns off, then turn the key to start.
Voltage Indicator
Lamp that indicates a low voltage condition.
Oil Pressure Indicator
Lamp that indicates a low oil pressure condition.
Water Temperature Gauge
Measures the engine coolant temperature.
Fuel Tank Cap
To remove the cap, turn counterclockwise.
Fuel Level Gauge
Displays the fuel level in the tank.
Power Outlet
Unit is equipped with a +12VDC, 20A power outlet.
Features & Controls