Ferris Industries IS4500ZC28D61CE - Manual (Page 25)

Regular Maintenance
23
LUBRICATION
Lubricate the unit at the locations shown in Figure 18
through 23.
Grease:
Use grease fittings when present. Disassemble parts
to apply grease to moving parts when grease fittings
are not installed.
Not all greases are compatible. Ferris Red Grease
(P/N 22285) is recommended, automotive-type high-
temperature, lithium grease may be used when this is
not available.
Oil:
Generally, all moving metal parts should be oiled
where contact is made with other parts. Keep oil and
grease off belts and pulleys. Remember to wipe fit-
tings and surfaces clean both before and after lubri-
cation.
Figure 18. Deck Lift Pivots
Figure 19. Mule Drive Idler Arm
*
*
Figure 20. Deck Lubrication
* - Use needle nozzle (later models)
RE-PACK RE-PACK
BEARINGS BEARINGS
ANUALLY ANUALLY
RE-PACK
BEARINGS
ANUALLY
RE-PACK RE-PACK
BEARINGS BEARINGS
ANUALLY ANUALLY
RE-PACK
BEARINGS
ANUALLY
Figure 23. Casters, Wheels & Suspension Arms
Figure 21. Control Handle Pivots & Seat Pivots
Figure 22. Center Lift Link