Regular maintenance, Check / add engine oil, Check / change air filter – Ferris Industries IS4500ZC28D61CE User Manual

Page 23: Check hydraulic oil level, Hydraulic oil filter change

Advertising
background image

Regular Maintenance

CHECK / ADD ENGINE OIL

Refer to Figure 13 for dipstick and oil fill locations.

Refer to the engine owners manual for specific engine
oil check and fill procedures. Also refer to the engine
owners manual for specific engine oil and filter change
procedures.

CHECK / CHANGE AIR FILTER

Refer to the engine owners manual for specific air filter
service procedures.

CHECK HYDRAULIC OIL LEVEL

NOTE: Do not open the hydraulic oil reservoir unless oil
is being added.

1. Visually check that the hydraulic oil level is filled to

the recess area (A, Figure 14) of the hydraulic oil
reservoir.

2. If necessary, remove the reservoir cap (B) and add

either Mobil 1™, 15W-50 synthetic oil or Castrol
Syntec™ 5W-50 oil. DO NOT use conventional oils.
Make sure area around the filler neck is free of dust,
dirt, or other debris.

HYDRAULIC OIL FILTER CHANGE

Change Interval: Every 500 Hours

Filter Part Number: 21357
NOTE: Removing the oil filter from the filter base will
drain the oil reservoir. Have a suitable container ready
to catch any spilled oil. Ferris recommends this be a
dealer-only service item.

1. Locate the hydraulic oil filter (A, Figure 15) behind

the oil reservoir.

2. Fill the new filter with oil. Lubricate the new filter

seal with a few drops of oil.

3. Remove the oil filter and quickly thread the new filter

onto the filter base until the gasket makes contact,
then tighten 3/4 of a turn more.

4. Refill reservoir with fresh oil to replace any oil lost

during filter change.

5. Raise the rear of the unit and secure with jackstands.

Chock the front wheels to prevent the unit from
rolling. Run the unit for several minutes to purge any
air from the hydraulic system and check the hydraulic
oil level.

IMPORTANT NOTE: Use caution after changing the fil-
ter; air in the hydraulic system may affect the respon-
siveness of the control levers. Repeat step 5 until the air
is out of the system.

Figure 14. Hydraulic Oil Reservoir

A.

Tank Recess (“FULL” level)

B.

Cap

A

B

Figure 13. Change Oil & Filter

A.

Oil Fill Cap

B.

Crankcase Dip Stick

Gas Model

Diesel Model

B

A

B

A

21

A

Figure 15. Hydraulic Oil Filter Location

A.

Oil Filter

Advertising
This manual is related to the following products: