Fortinet 5003A - Manual (Page 11)

FortiSwitch-5003A system FortiSwitch-5003A configurations
FortiSwitch-5003A System Guide
01-30000-77803-20080917
11
Figure 4: FortiSwitch-5003A base channel 1 HA heartbeat communication
Base and fabric 10-gigabit switching within a chassis
One FortiGate-RTM-XB2 provides 10-gigabit connections to both
FortiGate-5001A fabric channels. The FortiGate-RTM-XB2 also provides NP2
packet acceleration for each fabric channel. To effectively use NP2 acceleration,
packets must be received by the FortiGate-5001A board on one fabric channel
and exit from the FortiGate-5001A board on the same fabric channel or on the
other fabric channel. See the
FortiGate-RTM-XB2 System Guide for more
information.
Figure 5 shows a FortiGate-5050 chassis containing two FortiSwitch-5003A
boards and one FortiGate-5001A board. Using these components this chassis
supplies 10-gigabit connectivity between the external and internal network.
Figure 5: Example 10-gigabit connection between internal and external networks
1
2
2
3
4
5
SMC
1
SMC
POWER
5050SAP
SERIAL 1 SERIAL 2 ALARM
10/100 link/Act ETH0 Service
RESET ST ATUS Hot Swap
link/Act ETH0
ETH1 10/100
5000SM 10/100 link/Act ETH0 Service
RESET ST ATUS Hot Swap
link/Act ETH0
ETH1 10/100
5000SM
Base channel 1
HA Heartbeat
Communication
1
2
2
3
4
5
SMC
1
SMC
POWER
5050SAP
SERIAL 1 SERIAL 2 ALARM
10/100 link/Act ETH0 Service RESET ST AT US Hot Swap
link/Act ETH0 ETH1 10/100
5000SM 10/100 link/Act ETH0 Service RESET ST AT US Hot Swap
link/Act ETH0 ETH1 10/100
5000SM
Fabric Channel 2
10-gigabit Data
Communication
FortiGate-RTM-XB2
Module installed in RTM
slot 3 provides two
10-gigabit fabric channels
and NP2 acceleration for
the FortiGate-5001A board
FortiGate-5001A Board
Installed in FortiGate-5050
front panel slot 3
Fabric Channel 1
10 Gigabit Data
Communication
Internal 10-gigabit
Network Connected
to Fabric Channel 2
External 10-gigabit
Network Connected
to Fabric Channel 1
External
Network
Internal Network