Fortinet 5003A - Manual (Page 7)

FortiSwitch-5003A system Front panel LEDs and connectors
FortiSwitch-5003A System Guide
01-30000-77803-20080917
7
LEDs
Table 1 lists and describes the FortiSwitch-5003A front panel LEDs.
Table 1: FortiSwitch-5003A front panel LEDs and switches
LED State Description
OOS (Out of Service) Off Normal operation.
Red Out of service. The LED turns on if the
FortiSwitch-5003A board fails. The LED may also
flash briefly when the board is powering on.
ACT (Active) Green The FortiSwitch-5003A board is powered on and
operating normally.
Yellow Caution status. Caution status is indicated by the
fault condition of the HTY and FLT LEDs.
Off The board is not connected to power.
HTY (Healthy) Green The FortiSwitch-5003A board is powered on and
operating normally.
Off The board health system has detected a fault.
FLT (Fault) Off Normal operation.
Yellow Cannot establish a link to a configured interface or
another connection problem external to the
FortiSwitch-5003A board. This LED may indicate
issues that do not affect normal operation.
RST (Reset switch) Press and hold Reset for three seconds to restart the
FortiSwitch-5003A board.
Base Network Activity
LEDs
Solid
Green
Indicates this interface is connected to the 1-gigabit
base channel interface of a FortiGate-5000 board.
Table 2 on page 8 lists the base network activity
LEDs and the interface that each represents.
Blinking
Green
Indicates 1-gigabit network traffic on this interface.
Off No link.
Fabric Network
Activity LEDs
Solid
Green
Indicates this interface is connected to the
10/1-gigabit fabric channel interface of a
FortiGate-5000 board. Table 4 on page 10 lists the
fabric network activity LEDs and the interface that
each represents.
Blinking
Green
Indicates 10/1-gigabit network traffic on this interface.
Table 4 on page 10 lists the fabric network activity
LEDs and the interface that each represents.
Off No link.
MGMT, B1,
B2
(Management
and base
1-gigabit
LEDs) Link/Act
(Left
LED)
Solid
Green
Indicates this interface is connected with the correct
cable and the attached network device has power.
Blinking
Green
Indicates network traffic on this interface.
Off No Link
Speed
(Right
LED)
Green Connection at 1 Gbps.
Amber Connection at 100 Mbps.
Off Connection at 10 Mbps.