Fujitsu Siemens Computers X103 SFF - Manual (Page 18)

10 VFY-SCED103S, edition 1
Connecting the device to the mains voltage
100 V - 125 V
► Check the voltage setting.
!
The visible value must agree with the local mains voltage:
115 = 100 V to 127 V
230 = 200 V to 240 V
If an incorrect mains voltage is set, push the slide switch all the way into the other position
with a pointed object.
You may only operate the device, if the voltage for the device is set to the local mains
voltage.
1
2
► Connect the power cable to the device (1).
► Plug the power plug into a grounded mains
outlet (2).
Initial switch-on: Software will be installed
If the device is integrated into a network, the user and server details as well as the network protocol
are required during the software installation. Contact your network administrator if you have any
questions about these settings.
When you switch on the device for the first time, the supplied software is installed and configured.
Plan a reasonable amount of time for this, as this process must not be interrupted.
!
Once the installation has been started the device must not be switched off, unless the
installation has been completed.
During installation, the device may only be rebooted when you are requested to do so!
The installation will otherwise not be carried out correctly and the contents of the hard disk
must be completely restored.
You may need the licence number for Windows during the installation. The licence number is located
on a sticker on your device.