Assembling and dismantling low-profile units – Fujitsu Siemens Computers X103 SFF User Manual
Page 35
System expansions
VFY-SCED103S, edition 1
27
Assembling and dismantling low-profile units
!
Do not dispose of the slot cover. If you remove the board again, you must reinstall the slot
cover (cooling, fire protection or EMC regulations to be complied with).
Removing the holding plate
►
Open the casing (see "Opening the casing").
1
1
2
►
Undo the screws (1) and remove the
holding plate (2).
Installing a board
►
Push the board up to its slot as far as the stop.
►
Press the board into the slot so that it engages.
►
If necessary, plug the lines on the board again.
Removing a board
►
Disconnect the cables connected to the board.
►
Pull the board out of the slot.
Re-assembling the holding plate
1
1
2
►
Position the holding plate (2) so that it
secures the components.
►
Screw in the screws (1) previously removed
again.