Inserting the battery, P.15) – FujiFilm 1300 User Manual
Page 15
15
INSERTING THE BATTERY
Your camera requires one 3V lithium battery, type CR2/DL CR2.
To insert the battery:
1
Move the battery compartment cover release knob in the direction of the ar-
row.
2
Flip open the battery compartment cover.
1
2
3
Insert the battery following the instructions shown in the diagram on the inside
of the battery compartment cover. Important: Pay careful attention to the po-
larity of the battery as indicated by the
,
and
.
markings on the battery. The
battery must be inserted the correct way or the camera will not function.
4
When the battery has been inserted correctly, close the battery compartment
cover by pressing it until it snaps into place. If it does not snap into place, do
not force it but recheck the position of the battery to make sure it fits properly.
∗
Do not apply excessive force when opening or closing the battery compartment cover.
∗
One new lithium battery should be sufficient for approx. 200 exposures (based on our test
conditions).
∗
When traveling, take extra batteries to provide power for extra exposures. This is particu-
larly important if you visit areas where new batteries may be difficult to obtain.
∗
Check the battery capacity symbol before using your camera. (
→
∗
After changing the battery, reset the date to assure accurate date/time recording.
(
→
3
4