FujiFilm 1300 - Manual (Page 59)

59
TROUBLE SHOOTING
During operation
1 Replace the battery with a new one.
2 Press the POWER button.
3 The flash is charging. Wait until “ ” stops blinking
and is displayed. (The flash takes approx. 6 sec-
onds to charge.)
4 Remove the film, and load an unexposed film.
5 Photograph at 0.5 - 1.0 m (1.6-3.3 ft.) or use the
AF lock so that the AF lamp is lit.
● Pull the end of the film out to the FILM TIP mark
and correctly load the film.
● Check that the motor has stopped and that “ ” is
displayed. After that, open the camera back and
remove the film.
● Be sure not to move the button while film is
loaded in the camera.
● Please contact a FUJIFILM authorized distributor.
17
16
30
23
56
23
35
37
1 “ ” symbol is blinking.
2 Power switch is not on.
3 Is “ ” blinking on the LCD?
4 “ ” is lit on the exposure counter.
5 Is the AF lamp blinking in the mode?
● Did you pull the end of the film out to
the FILM TIP mark when loading the
film?
● Didn’t you open the camera back so
as to remove the film without checking
that the motor has stopped and that
“ ” is displayed?
● Did you operate the button in the
middle of the film?
● The camera is broken.
The shutter release won’t
trip.
After loading the film and
closing the camera back,
the exposure counter is
not displayed.
After loading the film and
closing the camera back,
the film is rewound and
“ ” is displayed.
The film rewound during
photographing.
“ ” is blinking and the
shutter can not be released.
Problems Possible Causes Solutions Page