Furuno 1732 - Manual (Page 115)

3. PLOTTER OPERATION
3-33
7. Press the SAVE soft key.
8. Press the [MENU] key to close the menu.
Editing a waypoint from the plotter display
You may change edit waypoints from the plotter display as follows:
1. Press the [MENU] key followed by the WAYPOINTS/ROUTES and
WAYPOINTS soft key to open the waypoint menu.
2. Press the WAYPOINT BY CURSOR soft key.
3. Operate the cursor pad to place the cursor on the waypoint which you want
to change. A flashing diamond mark appears on the waypoint when it is
correctly selected.
4. Press the EDIT/MOVE soft key. Three soft keys replace the EDIT/MOVE soft
key:
EDIT WPT:
Edit from the waypoint entry window.
MOVE WPT:
Move waypoint to new position with the cursor.
ERASE WPT: Erase waypoint, see paragraph 3.8.3.
5. Press appropriate soft key. If you pressed the EDIT WPT soft key the
waypoint entry window appears; edit data as appropriate. For MOVE WPT do
the following:
a) Operate the cursor pad to place the cursor on the location desired for the
waypoint. A line connects previous position and new position.
b) Push the [ENTER] knob. The waypoint moves to the cursor position and
its new position is recorded on the waypoint list. If the waypoint is set as
destination or is part of a route, you are asked if you are sure to move the
waypoint. In this case, push the [ENTER] knob to move the waypoint, or
press the [CLEAR] key to cancel.
7. Press the MENU key to finish.
BRIDGE
FISH
WP-002
34 ° 22. 3456'N 359.9 ° M TRIP NU
080 ° 22. 3456'E 59.9 nm 99.9 nm
RNG
BRG
CANCEL
+
Press to alternately display
range/bearing from own ship
to cursor, range/bearing from
original waypoint position to
cursor position.
Below is an example of the
range/bearing from original
waypoint position to cursor
position.
(2) Drag cursor to new position,
then push the [ENTER] knob.
Range and bearing from
own ship to cursor
34 ° 22. 3456’N FROM 5.3 ° M
080 ° 22. 3456’E FISH 1.45 nm
+
(1) Select waypoint to move,
then press EDIT/MOVE
and MOVE WPT soft keys.
16.0nm
Plotter display