Fluke Series II - Manual (Page 36)

Autotest and Central Setup
NetWare Print Server List
2
2-21
(Find Router) again cycles through a list of the
detected routers. This lets you see more routers than just
the first one detected. If the Network Assistant has
discovered more than one router, it assumes you want to
ping the busiest router, and so uses that router’s address.
Press (Apply Address) to see if the Source IP
address is duplicated on the local subnet. If a duplicate is
found, its MAC address is displayed. Select Apply
Changes on Exit and this process will occur when you
exit the screen.
SNMP
Press (SNMP Config) from the Central Setup to
access the Security Setup screen (Figure 2-19).
ace223s.bmp
Figure 2-19. Security Setup