Fluke Series II - Manual (Page 73)

OneTouch Series II
Users Manual
6-2
IP Trace Route
From the Connectivity Tests display, press (IP Trace
Route) to access the Trace Route screen (Figure 6-2).
Enter a target address by pressing the Target IP Address
box and using the Keypad (see “Manually Entering
Addresses” in Chapter 2). Press
to perform the Trace
Route and view the results.
ace619s.bmp
Figure 6-2. IP Trace Route
IP & NetWare Ping
From the Connectivity Tests display, press (IP &
NetWare Ping) to access the IP Ping Tests or NetWare
Ping display (Figure 6-3). If you haven’t done so already,
press
(IP Config) to configure the Network Assistant
addresses. You can enter addresses manually or use
DHCP (read “Central Setup” in Chapter 2).
ace620s.bmp
Figure 6-3. IP & NetWare Ping Display