FUJITSU DL3800 - Manual (Page 130)

USING SETUP MODE
User's Manual 5-42
Table 5.6 CONFIG Items and Options (Cont.)
NOTE: Underlined options are the factory defaults.
CONFIG Items Options Description
<CONT-PE> Detection of end of continuous
forms.
TRACTOR Paper end is detected by the sensor
on the tractor unit.
Paper-end unprinted area:
Continuous forms: About 80 mm
Botom feeding: About 35 mm
EDGE Regardless of paper end, printing
continues near to the edge of paper.
Paper-end unprinted area:
About 4.7 mm for both continu-
ous forms and bottom feeding
<==END==> Indicates the end of the CONFIG
item list. Press the FONT button to
print the first item, which is
<TEAROFF>.
Press the MENU button to print the
previous item. Press the ONLINE
button to reprint the <<FUNC-
TION>> menu.
Procedure
To change the printer configuration options, make sure that continu-
ous forms paper is loaded and then proceed as follows:
1. Enter setup mode.
Press the FONT button and the MENU button simultaneously
until the printer beeps. Wait for the printer to stop printing
and check that the following <<FUNCTION>> menu is
printed:
<<FUNCTION>>
SAVE&END MENU1 MENU2 HARDWRE ADJUST CONFIG DEFAULT LIST SELF-TST HEX-DUMP
V-ALMNT
#05 Chapter 5 2000.09.20, 2:37 PM 42