FUJITSU XG2000 - Manual (Page 18)

16 Installation
The following explains the names and functions of the components at the front of the
XG2000.
• Ports 1-20 XFP modules which connect to the IEEE802.3 ae/ak compliant
10 Gigabit network served by the XG2000. Connection method
varies depending on which XFP modules are installed.
• Link/Act LEDs (Green) Displays the condition of respective port.
Each LED lights when a link is established on its port.
The link is established about few seconds after the received
signal is detected.
• Dump Switch Used to collect maintenance information.
• Mng-LAN Used when performing maintenance or adjusting the settings
(LAN connection).
- Mng - LAN Speed LED (Orange) Lights if the link is 100BASE-TX.
- Mng - LAN Link LED (Green)
Lights when the link is established.
• Serial Port Used when performing maintenance or adjusting the settings
(Console connection).
• Status LED (Green) Lights when the XG2000 is in an operable state.
• Alarm LED (Orange) Lights when there is a problem with the XG2000.
• Power LED (Green) Lights when the XG2000 is receiving power.
1-2
XG2000 Components
This section explains the names and functions of the various XG2000 components, including the
various indicator LEDs.
XG2000 front
Mng-LAN
Port 1 - 20
upper stand : odd number
lower stand : even number
Mng-LAN Speed LED
Mng-LAN Link LED
Alarm LED (Alarm)
Power LED (Power)
Serial Port
Status LED (Status)
Link/Act LED
Link/Act LED Dump Switch