FUJITSU XG2000 - Manual (Page 36)

34 Installation and Operation
After connecting the peripheral units, connect the XG2000 power cords.
WARNING
• Do not touch the power plug with wet hands, as there is a risk of electric shock.
• Do not damage or remodel the power cords, as this may cause electric shock or
fire. Placing a heavy object on, pulling, excessively bending, twisting, or overheat-
ing a power cord can damage it, and may cause electric shock or fire.
• Do not use the XG2000 with a damaged power cord, a damaged power plug, and/
or a loose socket. Continued use under these conditions may cause a fire.
• If the power plug pins or socket holes are dusty, clean with a dry cloth. Continued
use with a dirty power plug or socket may cause electric shock or fire.
1.
Connect the power cords to the XG2000.
Insert the plug at the end of the power cord into the power inlet at the rear of the XG2000.
2-4-2 Connecting the power cords