Frymaster H20.5 SERIES - Manual (Page 17)

H20.5 SERIES ELECTRIC FRYERS
CHAPTER 3: OPERATING INSTRUCTIONS
3-4
3.1.1 Equipment Setup and Shutdown Procedures (cont.)
2. The display will indicate the programmed cook time and begin countdown.
3. If shake time is programmed, you will be notified to shake the product " X" seconds after the
cook cycle begins ( X= amount of time programmed). An alarm will sound and the display
will read and the product number selected. If no shake time is programmed will
not appear during the cook cycle.
4. At the end of cooking cycle, an alarm will sound; will be displayed and the
associated product switch indicator will flash. To cancel the cook alarm, press the flashing
product switch.
5. At this time, the hold time will be displayed (if programmed greater than 0) and countdown
will begin. When the hold time counter reaches 0, an alarm will sound. and the
product number selected is displayed. The hold alarm is canceled by pushing the switch.
If display is in use, hold time will count down invisibly until display is free.
3.1.2 Checking Temperature
A. Check the cooking oil/shortening temperature at any time by pressing the switch once. Check
the setpoint by pressing the switch twice.
B. During the idle periods, when the fryer is on but not in use, "
" should appear on both
displays on a single frypot computer. " " will appear on the display of the side that is
turned on in a dual pot computer. If not, check actual temperature and setpoint.
C. If you suspect a defective probe, check the cooking oil/shortening temperature with a
thermometer. Verify that the computer readout is reasonably close to your measured reading.
NOTE: The electronic circuitry can be affected adversely by current fluctuations and electrical
storms. If for no apparent reason the computer does not function or program properly, reset the
computer by unplugging the power cord and plugging it back in.
3.2 Programming The Computer Magic III.5
1. Activate the computer by pressing either switch.
2. To enter the program mode, first press the
switch. will appear in the left display. If
you have pressed this switch in error and do not wish to program, press the switch again.
Note: The computer will flash if cooking is in progress.
3. Press 1,6,5,0 in that sequence to enter the program mode.