FUJITSU DL9300 User Manual
Page 121
USING SETUP MODE
User's Manual
5-30
Table 5.4 HARDWRE Items and Options (Cont.)
NOTE: Underlined options are the factory defaults.
HARDWRE
Options
Description
Items
<FORMAT>
Number of
Number of
data bits
Parity bit
stop bits
7SPACE 1
7
Space
1
7EVEN 2
7
Even
2
7ODD 2
7
Odd
2
The data format also includes a start
bit. The mark is logical 1. The space
is logical 0.
<BAUD-RT> 150
The baud rate is in bps (bits per
300
second). Select the same baud rate as
600
used by your computer or modem.
1200
2400
4800
9600
19200
<PROTOCL>
Indicates data transmission protocol.
XON/XOF
The DC1 and DC3 codes are used.
DTR
The Data Terminal Ready signal is
used.
REV-CHL
The Reverse Channel signal is used.
<DSR>
IGNORE
DSR is ignored by the printer.
DETECT
DSR is detected by the printer.
<DUPLEX>
FULL
Simultaneous data transmission occurs
in opposite directions.
HALF
Data transmission occurs in either
direction, but not simultaneously.