FUJITSU DL9300 User Manual
Page 128
Setup Mode
USING SETUP MODE
User's Manual
5-37
Table 5.6 CONFIG Items and Options (Cont.)
NOTE: Underlined options are the factory defaults.
CONFIG Items Options
Description
<CUTLOAD>
Single sheet autoloading.
AUTO
Single sheet paper is automatically
loaded a certain time after you set
the paper.
BUTTON
Single sheet paper can be loaded by
pressing the LOAD button.
The following <LOADTIM> item is printed when
CUTLOAD:AUTO is specified for the <CUTLOAD> item.
<LOADTIM>
Autoload start time.
0.5, 1.0,
Autoloading starts when this
1.5, 2.0
amount of time passes after you set
2.5, 3.0SEC
single sheet paper.
<DECODE>
Command decode timing.
DIRECT
The printer decodes certain
commands immediately after
receiving data.
Example:
ESC SUB I, ESC CR P (DPL24C+)
ESC Q # (IBM XL24E)
QUEUED
The printer decodes commands after
storing all data (including com-
mands) in the input buffer. This
speeds data reception because the
printer does not require decoding
time during data reception.