FUJITSU DL9300 - Manual (Page 62)

User's Manual
Paper
Handling
PAPER HANDLING
3-5
(1) Paper table
→
Platen
→
Paper table (normal mode)
or
Rear stacker
(2) Front tractor
→
Platen
→
Rear ejection
(3) Rear tractor
→
Platen
→
Front ejection
(4) Front cut sheet feeder
→
Platen
→
Paper table (normal mode)
or
Rear stacker
(5) Rear cut sheet feeder
→
Platen
→
Paper table (stack mode)
or
Rear stacker
Avairiable combinations of paper paths and feed directions are
below:
• (1)+(2)+(3)
• (1)+(2)+(3)+(5)
• (1)+(3)+(4)
• (1)+(3)+(4)+(5)
When loading the paper from the rear cut sheet feeder, it is
impossible to store a lot of paper in the rear stacker.
NOTE
With the front cut sheet feeder installed, if you print paper from the
paper table or the front cut sheet feeder and specify the front
ejection, the printer blinks the FRONT indicator after ejecting the
paper to the paper table and stops printing before you start the next
printing.
To restart printing, remove the paper. You must remove paper one
by one.