FUJITSU DL9300 - Manual (Page 131)

USING SETUP MODE
User's Manual 5-40
EXITING AND SAVING This section describes how to exit setup mode save any changes you
made:
To exit setup mode immediately, select the SAVE & END function.
Any settings changed while in setup mode are saved as the new
power-on defaults for the printer. The new defaults remain active
until you change them again.
NOTE
The only way to exit setup mode without saving your changes is to
turn off the printer. When you turn the printer back on, the
previous default settings are used.
Procedure
To exit setup mode and save your changes using SAVE/END,
proceed as follows:
1. Print the <<FUNCTION>> menu.
The <<FUNCTION>> menu should be the last printed line on
the page. If the menu is not printed, press the ONLINE button
to print the menu. If you are using the SELF-TST or HEX-
DUMP function, press the FRONT DIR button instead of the
ONLINE button to print the menu. The <<FUNCTION>>
menu is shown below:
2. Select the SAVE/END function.
Make sure that the red cursor is positioned under SAVE &
END. Press the
↑
MICRO button or the
↓
MICRO button to
select SAVE & END. The printer exits setup mode and returns
online (the ONLINE indicator lights green). Any changes you
made while in setup mode are saved.
<<FUNCTION>>
SAVE&END MENU1 MENU2 HARDWRE ADJUST CONFIG DEFAULT
LIST SELF-TST HEX-DUMP V-ALMNT GAP-ADJ