Roadside emergencies – FORD F-250 User Manual

Page 157

Advertising
background image

4. Insert the hooked end of the jack
handle into the rear bumper drive
tube.

The handle will stop moving and
you will feel forward resistance to
turning when properly engaged.

5. Turn the handle counterclockwise
and lower the spare until you can
slide the tire rearward and the cable
is slack.

6. Remove the retainer through the center of the wheel.

Stowing the spare tire

1. Lay the tire on the ground with the valve stem facing up.

2. Slide the wheel under the vehicle
and install the retainer through the
wheel center.

3. Turn the jack handle clockwise
until the tire is raised to its original
position underneath the vehicle. The
effort to turn the jack handle
increases significantly and the spare
tire carrier ratchets when the tire is
raised to the stowed position. The spare tire carrier has a built-in ratchet
feature that will not allow you to overtighten.

4. Check that the tire lies flat to the frame assembly. Push against the
tire to make sure it is tightly seated under the vehicle. Loosen or
retighten if necessary.

5. If removed, install the spare tire lock into the bumper drive tube with
the spare tire lock key and jack handle.

6. The following steps are required to secure the support bracket (if
equipped) under the spare tire:
• Move the support bracket over the spare tire.
• Slide the support bracket over the eyebolt into the slot on the support

bracket.

• Tighten the eyebolt with tapered end of lug wrench leaving it

positioned at a right angle of the slot on the support bracket.

Roadside emergencies

157

Advertising
This manual is related to the following products: