Removing a memory upgrade module, Checking the memory capacity – Fujitsu Siemens Computers N6470 User Manual
Page 77
72 - Memory Upgrade Module
Removing a Memory Upgrade Module
Checking the Memory Capacity
Once you have changed the system memory capacity by replacing the installed module with a larger one,
be sure to check that your notebook has recognized the change.
Check the memory capacity by clicking [Start] > Control Panel (Classic View) > System. The amount of
memory is displayed next to “Memory (RAM):”
T
HE
MEMORY
UPGRADE
MODULE
IS
NOT
SOMETHING
YOU
SHOULD
ROUTINELY
REMOVE
FROM
YOUR
NOTEBOOK
. O
NCE
IT
IS
INSTALLED
,
YOU
SHOULD
LEAVE
IT
IN
PLACE
UNLESS
YOU
WANT
TO
INCREASE
SYSTEM
MEMORY
CAPACITY
.
1
Perform steps 1 through 5 of Installing a Memory
Upgrade Module.
2
Pull the clips sideways away from each side of the
memory upgrade module at the same time.
3
While holding the clips out, remove the module
from the slot by lifting it up and pulling towards the
rear of your LifeBook notebook. (Figure 33)
4
Store the memory upgrade module in a static
guarded sleeve.
5
Replace the cover by following steps 9 and 10 of
Installing a Memory Upgrade Module.
Figure 33. Removing a Memory Upgrade Module
A
FTER
INSTALLING
YOUR
ADDED
MEMORY
MODULE
,
YOU
MUST
RESET
THE
POWER
PLAN
PARAMETERS
IN
ORDER
FOR
THE
S
AVE
-
TO
-D
ISK
MODE
TO
OPERATE
PROPERLY
ON
YOUR
L
IFE
B
OOK
NOTEBOOK