Fujitsu Siemens Computers N6470 - Manual (Page 91)

86 - Troubleshooting
USB Device Problems
You have installed a USB
device. Your notebook does
not recognize the device, or
the device does not seem
to work properly. The device is not prop-
erly installed. Remove and re-install the device. See “Device Ports” on page 74.
The device may have
been installed while an
application was running,
so your notebook is not
aware of its installation. Close the application and restart your notebook.
Your device may not
have the correct soft-
ware driver active. See your software documentation and activate the correct driver.
PC/ExpressCard Problems
A card inserted in the
PCCard or ExpressCard
slot does not work or is
locking up the system. The card is not properly
installed. Remove and re-install the card. See “PC Cards/ExpressCards™”
on page 63.
The card may have
been installed while an
application was running,
so your notebook is not
aware of its installation. Close the application and restart your notebook.
Your software may not
have the correct soft-
ware driver active. See your software documentation and activate the correct driver.
You may have the
wrong I/O address
selected for your card. See your PC Card or ExpressCard documentation to determine
the required I/O address. Change the settings in Device Manager.
Your card and another
device are assigned the
same I/O address. Check all I/O addresses located within the Device Manager and
any other installed hardware or software to make sure there are
no duplications.
Problem Possible Cause Possible Solutions