Fender B-DEC 30 - Manual (Page 13)

B-DEC 3O
1
f e n d e r . c o m
ULT-4 Footswitch
(Sold Separately)
Button1 Button2 Button 3 Button 4
The ULT-4 Footswitch has four modes indicated by the three LED’s on the left side of the footswitch. Each mode LED will be lit
individually to indicate the current mode and if no LED’s are lit the footswitch and amp are in Tuner mode. The footswitch will
only control the amp if the B-DEC™ 30 is in Play mode or Tuner mode. In Mode’s 1-3 the display will show the amp the current P,
U, or S Preset that is loaded on the amp and in Tuner mode the display will show the current note. You cannot change footswitch
modes while the Phrase Sampler is recording or overdubbing.
MODE1-QuickAccessMode:
Button 1: Hold for Tuner, Press and release for Mode 2
Button 2: Loads Song QA1 or Default QA1 if no song is currently loaded. Also turns on the LED above the button.
Button 3: Loads Song QA2 or Default QA2 if no song is currently loaded. Also turns on the LED above the
button.
Button 4: Loads Song QA3 or Default QA3 if no song is currently loaded. Also turns on the LED above the
button.
MODE2-Down/Up/StartStopMode:
Button 1: Hold for Tuner, Press and release for Mode 3
Button 2: Decrements to the next Preset (P or U) or Song.
Button 3: Increments to the next Preset (P or U) or Song.
Button 4: Starts or Stops a pattern if the user is on a U or P preset. If the user is on a S preset the song starts and
the footswitch switches to QA mode so that the user can access the 3 QA presets associated with that
song during playback. Upon completion of the song the footswitch will automatically return to mode
to so that the user can select the next song
MODE-PhraseSamplerMode:
Button 1: Hold for Tuner, Press and release for Mode 1
Button 2: Starts/Stops phrase sampler playback. LED will blink if the amp is finishing overdubbing a loop and will
turn on once playback begins or off when playback has halted.
Button 3: Starts/Stops phrase sampler recording. LED will turn on once recording begins and off when playback
has halted.
Button 4: Starts/Stops phrase sampler overdubbing. LED will blink if the amp is waiting to overdub on the next
pass or stop at the end of the current pass and will turn on once overdubbing has begun or off when
overdubbing has finished.
TUNERMODE:
The four red LEDS on the top of the footswitch, along with the green LED in the middle will be used to indicate whether
the user is sharp, flat, or in tune.
Any Button: Pressing and releasing any button will cause the amp to exit from the tuner and return to the previous
footswitch mode
���������� ������
������
������
���
����
����������
��� ���
�� ������
������ �������