FUJITSU MB96300 - Manual (Page 27)

SK-96370-144PMC-GDC User Guide
Chapter 4 Connectors
© Fujitsu Microelectronics Europe GmbH - 27 - FMEMCU-UG-960014-10
4.6 In-Circuit-Programming Connector (X4)
There is a flash-programming socket on the starter-kit, which makes it possible to program
the flash MCU with a special programming adapter. Mode pin MD0 and reset signal are also
available at this connector.
Figure 4-5: In-circuit programming connector
Pin Number Pin Signal Description
1 NC Not used
2 NC Not used
3 MD0 MCU mode pin MD0
4 NC Not used
5 RSTX MCU reset signal
6 SIN3 UART2 receive data
7 SOT3 UART2 transmit data
8 SCK3 UART2 clock
9 VCC Board supply voltage
10 GND Ground
Table 4-4: In-circuit programming connector