FUJITSU MB96300 User Manual
Page 31
SK-96370-144PMC-GDC User Guide
Chapter 5 Programming the internal Flash memory
© Fujitsu Microelectronics Europe GmbH
- 31 -
FMEMCU-UG-960014-10
ON
OFF
DIP-Switch S1
(RUN Mode)
MD0 MD1 MD2 nc
1
2
3
4
4) After programming the Flash-device, switch off the power supply and set back the
mode according to the usage of the application, e.g.:
5) Power on the board. The user application is started directly.
5.2 Synchronous
Mode
In order to program the Flash-ROM synchronously special third-party soft- and hardware has
to be used, e.g. GALEP-4 from
www.conitec.de
. This tool is not available for free.
A dedicated Flash programming socket (X4) is provided on the evaluation-board for direct
connection to this programmer.
X4: Flash programming socket
Figure 5-1: Flash Programming Socket
n/c 1
MD0 3
RST 5
SOT3 7
VCC 9
2 n/c
4 n/c
6 SIN3
8 SCK3
10 GND