FORD FCSD TECHNICAL TRAINING FCS-14000-DL - Manual (Page 66)

LESSON 3: POWERTRAIN
Loosen #1 Camshaft Bearing Cap Bolts
Mark the cam caps for proper reinstallation.
NOTE: The camshaft bearing caps must be installed in their original locations. Record camshaft bearing cap
locations.
Loosen the camshaft bearing caps. Start with the #1 cap because it contains a thrust surface groove. If the cam
were to be moved in some fashion with this cap intact, the cap could be damaged or broken.
Remove the remaining cap bolts according to Workshop Manual procedures.
2005 Expedition/Navigator New Model Technician Training 02-SEP-04 3-30