FOCUS Enhancements Bridge/Router MX-4DV User Manual
Page 30
MX-4 DV U
SER
G
UIDE
C
HAPTER
3
26
Post Production Configuration
This configuration is useful in a Post-Production environment—where you mix two or more pro-
grams together.
This installation example below shows the use of DV equipment in combination with analog
equipment.
1
Connect the VIDEO OUT from a DV VTR 1 to DV IN 1 on the MX-4 DV rear panel.
Connect the AUDIO OUTs from a DV VTR 1 to AUDIO IN 1 on the MX-4 DV rear panel.
2
Connect the VIDEO OUT from a DV VTR 2 to DV IN 2 on the MX-4 DV rear panel.
Connect the AUDIO OUTs from a DV VTR 2 to AUDIO IN 2 on the MX-4 DV rear panel.
3
OPTIONAL – Connect an audio source (CD player, tape deck, or microphone) to AUDIO IN
4 on the MX-4 DV rear panel.
4
Connect a Composite-type monitor to the PREVIEW OUT jack on the rear panel.
5
OPTIONAL - Connect a Character Generator (CG) to the OUT Y/C jack on the rear panel.
With this configuration you can superimpose titles from the CG atop the output signal.
6
Connect a recording VTR to the OUT Y/C jack on the rear panel.
If you are using the optional Character Generator (described above), connect the output from
the CG to the VTR input.
7
Connect an Output Monitor to the recording VTR so you can see the signal being recorded.
8
Connect the power cord and transformer to the MX-4 DV rear panel. Refer to “Power Connec-
tor” on page 22 for instructions.
Use the Route function (“Route” beginning on page 73) to make sure your devices are directed to
the correct MX-4 DV channels.