FOCUS Enhancements Bridge/Router MX-4DV - Manual (Page 92)

MX-4 DV U SER G UIDE C HAPTER 8 88
4 If this is the Multi-PIP configuration you want to use, move on to the next step: otherwise…
a Press the number on the keyboard that corresponds to the PIP configuration you want to
use. (Refer to Table 11, “Multi-PIP Screen Configurations,” on page 87, at the beginning
of this section.) MX-4 DV displays the configuration on the Preview screen.
5 Use the ARROW keys to move the flashing border to a tile where you want to display the sec-
ondary input source: or, press SHIFT + ARROW KEY to move to the beginning or end of a row or
column.
6 Press NEXT / C . Channel C, in this example, carries the video of the graphic word “Kong.” That
image appears in the tile you selected in the preceding step.
7 Repeat the two preceding steps for any other tile or tiles you want. You can direct any input
signal to any tile by using one of the
NEXT keys.
8 When the Preview screen looks the way you want, press PLAY to cut to the Multi-PIP on the
output; or use the T - BAR to fade the Multi-PIP to the output.
9 Press SHIFT + PIPS to return to the Preview screen.
Using Freeze Effect with Multi-PIPs
You can apply the Freeze effect (refer to “Freeze” on page 79) to any Multi-PIP tile.
To use the Freeze effect with Multi-PIPs:
1 Use the ARROW keys to select a Multi-PIP tile.
2 Press FREEZE .
3 Press FREEZE again to release the effect.